GSF650

Jack Up Kit to fit Suzuki Bandit GSF650

Front Wheel Bearings

Supplied As A Pair

To Fit GSF1200 96-05 and GSF650 07 On

Stainless Steel Exhaust Headers Comes Complete With Spring Hook, Stainless Exhaust Springs, Stainless Header Bolts, Header Gaskets, Collector Box Gasket & Link Pipe Clamp

High Quality 304 Grade Polished Stainless Steel

Less Restrictive 4-1 Collector Will Improve Power Over Standard Headers

Full Stainless Steel Construction So Collector Will Not Rot Like On Original Suzuki Pipes

Will Fit With Standard Suzuki End Can/Link Pipe As Well As Most Aftermarket Link Pipes

68mm Oil Filter Wrench

Front Brake Master Cylinder Repair Kit

Kit Contains Quality Replacement Parts To Repair Master Cylinder

Black Aluminium Oil Cooler

Good Quality Pattern Part

Direct Replacement For Original Part

Will fit:  GSF600 1995-2004 and GSF650 2005-2006

Carburettor Float Needle Valves Available as a Pack of 1 or 4 High Quality Replacement Part

Carburettor Inlet Rubber Cylinder Head O-Rings

Original O-rings Tend To Flatten And perish Over Time  

If Removing The Inlets Then Its Recommended To Change The O-rings To Prevent Air Leaks

4 Supplied

Will fit:

GSF600 ALL MODELS

GSF1200 Mk I Only 1996 - 2000

GSF650 2005 - 2006

Clutch Push Rod (Bolt) Repair Kit

Kit Contains Quality Replacement Parts To Repair Clutch Push Rod

2 x Pairs of EBC Brake Pads 1 x FA229HH 1 x FA231HH

Oxford Oximiser EL572 - 888 Motorbike Motorcycle 12V Battery Charger

The Oximiser 888 can be left permanently connected to provide guaranteed long term battery care.

Suitable for all 12V battery types up to 30Ah, including Gel, MF and Acid batteries. Heavily discharged batteries as low as 4.1V can be charged if the battery is not damaged.

Included with the charger is a removeable power lead and a permanent ring connection lead with fuse and weatherproof cap.

Fork Oil Seals For GSF600 2000-2005 and GSF650 2005-2016

Front caliper rebuild kit

Kit Contains:

4 x Stainless steel pistons

4 x 30mm dust seals

4 x 30mm pressure seals

2 x Rubber boots

2 x Rubber gaitors

2 x bleed nipples

2 x dust caps

4 x copper banjo washers

2 x Pins & Clips

Front caliper stainless steel pistons and seals

Kit Contains:

4 x Stainless steel pistons

4 x 30mm dust seals

4 x 30mm pressure seals

Cam Cover/Rocker Cover Gasket

Genuine Suzuki Part Supplied In Original Sealed Packaging

Original Part 11173-18H00

Genuine Suzuki Part in Sealed Suzuki Packaging

Rocker Valve Cover Gasket/Seal

Gaskets Fit Under Cam Bolts on Cylinder Head Cover (Rocker Cover)

Part Number 7 on Parts Diagram

Part Number 11191-27E20-000

Supplied Singly or as a Pack of 8

Will Fit:GSF600 Bandit 95-04,GSF650 05-16,GSF1200 Bandit 96-05, GSF1250 Bandit 07-16

17mm Nut Fitment for Easier Fitting and Removal

With Lock Wire Hole

JT Gold X-Ring Chain and Sprocket Kit

To Fit Suzuki Bandit GSF600 00-05 and GSF650 05-06 (non ABS)

Lextek CP1 Stainless Steel Exhaust Can

Moto GP Style Exhaust With Carbon Fibre Tip

51mm (2") Slip On Can So Will Fit Most Aftermarket Link Pipes

Lifetime Warranty

Comes Complete With Can Strap & Exhaust Clamp (Not shown in photos)

Lextek OP1 Matt Stainless Steel Oval Exhaust Can

51mm (2") Slip On Can With Link Pipe

To fit GSX650F 07-16, GSX1250F 10-16, GSF650 07-14 and GSF1250 Bandit 10-16

Comes Complete With Removeable Baffle, Can Strap & Exhaust Clamp

OptiMate 4 Quad Program is the ultimate battery charger for 12V lead-acid and 12.8V lithium batteries on your motorcycle, ATV and other power-sport vehicles. 

Quad Program - select program 2 or 4 to charge through the BMW controlled 12V socket or program 1 or 3 for your Triumph socket or direct to the battery (seperate lead required). 

Select your battery type and the OptiMate 4 Quad will go through its fully automatic multi-step program to bring the battery safely to full charge.
 

Technical Specifications:

Recommended for: AGM, GEL and STD 121V batteries from 4-60Ah and Lithium (LiFePO4) 12.8/13.2V batteries from 2-15Ah
Charging Amps: 1.25A (constant current)
Charging Volts: nominal: 12V & 12.8V range: 0.5V-14.4V
Operation: 4 Charge programs
Steps: 9
Features: OptiMate 4 Quad Program tests before and after charging and can recover a flat lead-acid and lithium (LiFePO4) battery from as low as 0.5 volts.
Use: Indoor / outdoor (lowest temperature -40°c)
Input: Global (100-240V 50-60Hz), high efficiency (CEC listed).
Style: Weatherproof case with wall mounts, with 6ft / 180cm AC supply lead and 6ft / 180cm charge lead ending in SAE connector.
Save: Low Volt Start of 0.5V + 2-step* desulphation recovery (*1-step low volt pulse save during CAN-bus mode).
Safe: No risk of overcharging. Totally safe for vehicle electronics. Sparks suppressed. Safe for long-term battery maintenance. Automatic shut-down if short-circuited or battery disconnected.
Included: O1 weatherproof battery lead, O4 battery clamps and hanging hook.

Set Of 4 Blanking Plates For When Removing The P.A.I.R System That's Fitted To The MKII Bandit Engines

Made From 2mm Thick Bright Annealed Stainless Steel To Give A Polished Look

The P.A.I.R. System Isn’t Required For The UK As An Emissions Test Isn’t Part Of The M.O.T These Were Fitted Purely To Allow the manufacturer To Get Around The Emissions Controls When These Bikes Were New Many People Remove The Whole System As They Are Not Nice Looking, Go Rusty And Are Extra Weight On An Already Heavy Bike

Blanking Plugs Are To Cover Holes Left From Removing Hoses From Air Box and Carb This Will Stop It Drawing In Air/Dust etc

Kit Comes Complete With 4 Stainless Plates, 4  Gaskets, 2 Bungs, 8 Stainless Bolts & 8 Stainless Washers

Will Fit: GSF600 Bandit 2000-2004 GSF1200 Bandit 2001-2006 GSF650 Bandit 2005-2006

Pair of Fork Oil Seal Retaining Clips

Direct Replacement Part

Will fit:

All GSF400, GSF600 and GSF650 Bandits

GSR600 2006-2010, GSR750 2011-2015, GSX650F 2008-2016, GSX1100G 1991-1996

Rear Brake Master Cylinder Repair Kit

Kit Contains Quality Replacement Parts To Repair Master Cylinder

Rear Wheel Bearing & Seal Kit

Contains: 2 x Rear Bearings & Seals, 1 x Sprocket Carrier Bearing

Good Quality Pattern Parts

Fits GSF600 95-05, GSF650 05-16, GSF1200 96-05

Visbella High Temperature Black RTV silicone Gasket Maker

Visbella® High Temperature RTV Silicone is designed for Automobile production of bonding and sealing.

This product is a one component RTV Silicone sealant, curing completely without odor release.

Acid & Neutral solidified into elastic rubber strip after full cure.

It’s used for in engine, high-temp pipe system, gearbox, carburetor etc.

Quality Stainless Link Pipe

Will fit almost any 51mm After Market Can

Manufactured from 304 Grade Stainless Steel

Fits:

GSF600 All Years

GSF650 05-06 OIL COOLED ONLY

GSF1200 ALL YEARS

8 x High Quality A2 Stainless Steel Studs with 8 x Stainless Flange Nuts & 4 x Exhaust Gaskets

Ideal Upgrade For Original Bolts As The Studs Have Allen Key Hex Head Machined Into Them Which Makes Fitting/Removing Much Easier Than Original Bolts

Will Fit Bandit 600/650/1200/1250 ,GSXR600, GSXR750, GSXR1000, GSXR1100, GSX1400 and GSX1300R Hayabusa

Stainless Steel Exhaust Complete System

Comes Complete With Everything Required For A Straight Swap:

Stainless Headers, Link Pipe, Carbon Fibre OP8C Road Legal Can, Spring Hook, Stainless Exhaust Springs, Stainless Header Bolts, Header Gaskets, Collector Box Gasket & Clamps